Thermal Fluid Heater JST 1-1.0-Y.Q
Steam boiler Working Pressure:1.25 Mpa
Steam Temperature:1

Boiler photo and drawing :

   Thermal Fluid Heater  installation drawing :

  Thermal Fluid Heater  parameter :

How to use? (After finished piping)

A: press “ON” button on control panel

B: check pressure gauge, when up to 0.7Mpa, open safety valve, and use steam

Safety assurance:

A: pressure: through pressure control, when steam pressure up to set pressure, boiler shut off automatically.

B: with high water level, low level, super high level protection

Advantage:

1.Safer Operation
Electric boilers are flameless and safer. This eliminates the risk of flareback, firebox explosions, and smoke damage.

2.Economic

Electrical wiring is less expensive to run than steam piping. Not having a separate boiler room or vented exhaust saves money

1).Please confirm with us ,which type will you need ?Funel or oil or electricity ?

2)Please confirm with me ,what is the steam output ?The capacity .

3).Will you need one piece or several pieces ?